November 6, 2015

Flashing Of MediaTek Stock ROMs With SP Flash Tool on MTK Android Smartphones-steps

SP Flash Tool is a user friendly tool designed for MediaTek devices like Tecno, Infinix, Innjoo, Gionee, BML, etc. SP Flash Tool is a great piece of software allows you to flash your Smartphones ROMs (Stock or Custom). It supports flash stock, installing custom recovery, Unbrick the Bricked Smartphones and firmware updates for your Mediatek devices. Below are the guide to Flash Custom ROMs using SP Flash Tool on Windows Computer.

Need Materials Used For SP Flash Tool

1. SP Flash tool - Download it here

2. Android ADB drivers - Download it here

To Flash a Backup or ROM with SP Flash Tool

Make Sure You Backup Your Rom

Disclaimer: Don't flash another preloader and DSP_BL blocks! It is always dangerous! On some models of phones you will have a brick even if you download these blocks read from a phone which you own! Always remove from them marks in SPFT! ALWAYS have a working backup of your original ROM before you flash a new unknown ROM.Shelaf take no responsibility for any harm done while attempting this

1. Disconnect your phone if connected with USB to the PC, and turn OFF the phone completely, also take out the battery if possible (ignore this step 1, for phones with built in battery).

2. Now connect or reconnect the USB cable to the phone with the PC while the phone is still off, Windows should pop up and begin to install the MTK65XX Preloader Drivers, this only happens if you installed the Mediatek Preloader USB Drivers correctly in Windows. After they successfully installed, disconnect the USB cable again.

3. Open the folder you extract it to and locate flash_tool, double click on it to open.

Flash a Backup or ROM with SP Flash

  • Once it is launched, hit theScatter-loading button

  • SP Flash

    4. Locate the scatter file in the backup or Rom of the phone that you downloaded. It's usually a text file. (ALWAYS only load a ROM that is 100% made for your phone, flashing a wrong ROM may make your phone non-bootable).

    5. Hit the "Download' button in SP Flash Tool to begin the flashing process

    Flashing Process

    6. Connect your Smartphone to the computer with a USB without battery, if possible to remove. Press, Vol Down or Up so that the computer can easily detect the phone.

    7. Once the Flashing is complete you will see a green circle confirming... With Download OK

    8. Close the SP Flash Tool and disconnect your phone from the computer. Congratulation, your Smartphone is now flashed with the new Stock Rom you downloaded.

    If your phone bootloops, remove battery and boot into recovery mode. Factory reset the phone.

    Check Out: Android Emulators for Linux | How To Run Android Apps on Linux Ubuntu, LinuxMint, Fedora, ArchLinux, OpenSUSE, Mageia, CentOS- Guides

    No comments:

    Post a Comment